Filter
Top Products
15
Appendix
TipsSettingsPlayback
Contents
Front panel Rear panel IndexRemote
Connections
Speaker connection
NOTE
• Disconnect this unit’s power plug from the power outlet before connecting the
speakers.
• Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and – sides touch each other (vpage40 “Protection circuit”).
• Never touch the speaker terminals while the power cord is connected.
• Use speakers with impedances within the ranges shown below to suit how they
are used.
Speakers used Impedance
SPEAKERS A
(Standard connection)
4 – 16 Ω/ohms
SPEAKERS B 4 – 16 Ω/ohms
SPEAKERS A and SPEAKERS B 8 – 16 Ω/ohms
SPEAKERS A and SPEAKERS B
(for bi-wiring connections)
4 – 16 Ω/ohms
Connecting the speakers cables
Carefully check the left (L) and right (R) channels and + (red) and – (black)
polarities on the speakers being connected to the unit, and be sure to
connect the channels and polarities correctly.
1
Peel o about 3/8 inch (10 mm) of
sheathing from the tip of the speaker
cable, then either twist the core wire
tightly or apply solder to it.
2
Turn the speaker terminal
counterclockwise to loosen it.
3
Insert the speaker cable’s core wire to all
the way into the speaker terminal.
4
Turn the speaker terminal clockwise to
tighten it.