Filter
Top Products
30
Appendix
TipsPlaybackConnections
Contents
Front panel Rear panel IndexRemote
Settings
Setting the remote signal receiving function of the remote control unit
When you connect a IR receiver (sold separately) to the REMOTE
CONTROL IN connector of this unit, use the following procedure to
disable the remote signal receiving function of this unit. When the function
is enabled, you can not perform operations with the remote control unit.
By default, this function is enabled.
SPEAKERS BSPEAKERS A
Disabling the remote signal receiving
function of the remote control unit
1
While the remote signal receiving function of this unit
is enabled, press and hold SPEAKERS B for about 5
seconds.
The mute indicator flashes once, and the remote signal receiving
function is disabled.
Enabling the remote signal receiving
function of the remote control unit
1
While the remote signal receiving function of this unit
is disabled, press and hold SPEAKERS A for about 5
seconds.
The mute indicator flashes three times, and the remote signal
receiving function is enabled.