Mitsubishi Electronics MDT3215 Car Video System User Manual


 
1-12
English-10
10. Recommended Adjustment
To reduce the risk of “image persistence”, please adjust the
following items based on the application being used.
“SCREEN SAVER” (See page 23), “SIDE BORDER COLOR”
(See page 23), “DATE & TIME” (See page 26), “SCHEDULE”
(See page 26).
11. When the monitor is installed in the
portrait position
Remove the stands (feet).
Left edge should be the upper edge from front view.
12. Installing and removing stand
How to install stand
1. Please turn monitor off.
2. Place stand onto monitor with the long ends of the feet in
front of the monitor.
3. After inserting stand in guide block, fasten thumbscrews
on both sides of the monitor.
How to remove the stand
1. Spread the protective sheet on the flat surface, such as
a desk.
2. Place monitor on the protective sheet.
3. Remove thumbscrews with a screwdriver or with your
fingers and place them in a safe place for reuse.
Stand
Thumbscrews
NOTE: Place stand onto monitor so that the long end of
the feet are in the front.
CAUTION: Handle with care when mounting the display
stand and avoid pinching your fingers.
13. When using external speakers
We recommend to using the option speakers designed for
the MDT321S.
The external speaker terminals of the MDT321S may be
connectable with the speaker plug of a mainframe sound
speaker.
It this case, please exchange the lead connector of a
mainframe sound speaker for an attached speaker plug.
Speaker terminal
Speaker plug
Fixed cable and speaker plug.
Insert the fixed cable and speaker plug to the speaker terminal.
Standard cable
Insert the negative (-) side of a standard speaker cable into the
negative (-) side of the speaker plug. The negative side of a
standard speaker cable has a stripe running the length of the cable.
Insert remaining wire into the positive (+) side of the speaker plug.
Hold down on the small lever on the speaker plug to insert cable.
How to use the attached speaker plug
Downloaded From TV-Manual.com Manuals