Filter
Top Products
10
GETTING STARTED
Before you make the first connection to your L70, you should have the arrangement of your listening
room/home theatre components and furniture mapped out, at least initially. Unfortunately, a discussion
of the vital questions of loudspeaker placement and listening/viewing positions is beyond our scope here.
Suffice it to say that these two questions will influence your system’s ultimate performance every bit as
powerfully as your selection of electronics and speakers. Your NAD audio specialist dealer will be happy
to advise you, and to recommend reference materials.
NOTE
It is not absolutely necessary but one may find it easier to use the HTR L70 remote handset in conjunction
with the front panel buttons to configure your L70. See “Using the HTR L70 Remote”.
DEALING WITH HUM AND NOISE
Hum and noise sometimes prove a challenge in complex, multichannel audio systems. Note these
considerations to help prevent hum and noise problems:
• Power your system’s entire audio components from AC outlets originating from the same circuit of
your house wiring. As far as possible, power all audio components from the same outlet, or adjacent
outlets on the same circuit. It may be useful to power video displays (and computers!) from outlets on
another circuit, especially if that circuit is supplied from the other “leg” of the house wiring.
• Do not bundle analog audio cables with AC power cables, or with coaxial digital-audio cables. It is
best if they cross at right angles if they must be in close proximity.
• Employ high-quality, well-shielded audio cable throughout, and ensure that all connections are secure.
•A pencil-eraser can be used to burnish copper- and gold-plated contacts to ensure good, low-
resistance contact; specialized contact-cleaners can also be useful. Avoid unnecessary unplugging and
re-plugging, since the gold (or copper) contact plating of typical cable connectors, even very high-
quality ones, is very thin and easily worn.
Track down hum/noise problems one component at a time, working backwards from the receiver. That
is: Connect the speakers to the receiver only, and check for hum. Then connect one component only (a
VCR, for example) alone, with no other components connected and check for hum. Connect additional
components, one at a time, to the receiver and check for hum. At each stage, if hum/noise appears,
examine the audio cabling and AC-power routing of the new component. In some cases, moving the new
component’s AC cord to a different outlet, or installing a ground-lift (3-to-2-prong adaptor) on its power
cord, will eliminate the hum.
ABOUT THE ON-SCREEN DISPLAYS (OSD) AND FRONT-PANEL READOUT
The L70 receiver employs two; self-explanatory systems of on-screen display “menus” one for the L70
receiver, the other for the internal DVD player. These “menus” will appear on the connected video
monitor/TV and are required during the setup process (useful in day-to-day operation); so be sure to
connect the monitor/TV before proceeding with setup.
NOTE
The receiver’s on-screen displays (OSD) are carried to either one of the S-Video or composite MONITOR
OUT jacks as defined by the receivers OSD SELECT switch. In addition to the receiver’s OSD, there is
an internal DVD’s OSD; designed for greater enjoyment and flexibility when watching DVD/CDs by
allowing simultaneous output of the OSD on S-VIDEO, COMPOSITE, COMPONENT (NTSC models) and
SCART/RGB (PAL models).
SETTING UP THE L70
Setup
ENGLISH FRANÇAIS
DEUTSCH
NEDERLANDS
ESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
L70 IM english 13/3/05 4:33 pm Page 10