Filter
Top Products
12
INPUT SELECTOR
•From the OSD’s <MAIN MENU> screen, select the <INPUT SELECTOR> menu item using the HTR L70
remotes’ and “Enter” keys.
• Using the keys select the video input (DVD, SAT, VCR, and VIDEO 4) you wish to configure.
• Use the keys to move to the <Audio> line, and then use the keys to select the analog
audio input you wish to be linked to that input (usually, this will be the same, i.e., “VCR” with “VCR,”
“Video 4” with “Video 4,” and so on).
NOTE
It is not necessary to have an analog audio input connected for every video input you employ. In fact,
in some cases-for example for a CAB/SAT-it may be preferable to make only a coaxial or optical digital
audio link to the L70 for audio playback. This avoids possible confusion, and ensures that the L70’s
high-performance surround and digital audio circuitry will always be employed.
• Now use the keys to move to the <DIGITAL INPUT> line and select the digital input you wish
linked to that input.
• If you set <DIGITAL INPUT> to “ANALOG,” no incoming digital signal will be selected by that input.
(Set an input’s <DIGITAL INPUT> to “ANALOG” only if you wish to ensure that that input will not play
an incoming digital bit stream, even if one is present.)
NOTE
• The combination of analog-audio input and digital input assigned above will always be recalled
whenever that input is selected via the front-panel INPUT SELECTOR, or the HTR L70 remote’s input-
select keys.
• That signals from digital inputs are not available on the analog VCR OUT jacks.
SETTING UP THE L70
Setup
ENGLISH FRANÇAIS
DEUTSCH
NEDERLANDS
ESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
L70 IM english 13/3/05 4:34 pm Page 12