Filter
Top Products
Appendix
Español
Français
Deutsch
English
Italiano
Installation E - 12
Raise and Lower Monitor Screen
The monitor may be raised or lowered in either Portrait or Landscape
mode.
To raise or lower screen, place hands on each side of the monitor and
lift or lower to the desired height (Figure RL.1).
Screen Rotation
Before rotating, the screen must be raised to the highest level to avoid
knocking the screen on the desk or pinching your fingers.
To raise the screen, place hands on each side of the monitor and lift up
to the highest position (Figure RL.1).
To rotate screen, place hands on each side of the monitor screen and
turn clockwise from Landscape to Portrait or counter-clockwise from
Portrait to Landscape (Figure R.1).
To toggle the orientation of the OSM menu between Landscape and
Portrait modes, press the RESET button while OSM menu is off.
Tilt and Swivel
Grasp both sides of the monitor screen with your hands and adjust the
tilt and swivel as desired (Figure TS.1).
Remove Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest
position (Figure RL.1).
3. Place monitor face down on a non-abrasive surface (Place the
screen on a 55mm platform so that the stand is parallel with
the surface.) (Figure S.1).
4. Press the " " portion with your index finger and at the same
time slide the lower stand cover. (Figure S.2)
Next, lift up the stand, remove the lower stand cover, then go
on to remove the upper stand cover. (Figure S.3)
CN912B-2/LCD1810X/78135322 00.5.26, 0:03 PM27