Filter
Top Products
12
AccuColor
®
Control Systems
ACCUCOLOR
®
CONTROL SYSTEM: Seven preset color settings.
For preset settings: 1, 2, 3, and 5, the following levels can be adjusted:
TEMPERATURE: Adjust the white temperature by increasing or decreasing this
setting. A lower color temperature will make the screen reddish and a higher color
temperature will make the screen bluish.
WHITE (White Balance): If TEMPERATURE needs further adjustment, the individual
R/ G/ B/ levels of the white point can be adjusted. To adjust the R/G/B levels,
CUSTOM must be showing as the TEMPERATURE selection.
HUE: Adjusts the hue of each color
*1
. The change in color will appear on screen
and the menu color bars will show the amount of adjustment.
SATURATION: Adjusts the color depth of each color
*1
. Press the “RIGHT” button
and the color vividness increases.
OFFSET: Adjusts the color brightness of each color
*1
. Press “RIGHT” button and the
color Brightness increases.
*1: RED, YELLOW, GREEN, CYAN, BLUE, MAGENTA
The sRGB and NATIVE, color presets are standard and cannot be changed.
The PROGRAMMABLE setting can only be adjusted using color calibration software
such as NEC’s GammaComp or Spectraview II.
Tools
SHARPNESS:
This function is digitally capable of keeping a crisp image within any
resolution at any time. This setting can be set independently for different signal
timings (resolution settings).
DVI SELECTION: This function selects the DVI input mode. If the DVI selection changes,
you must restart the computer.
AUTO: When using the DVI-D to DVI-D cable, the DVI SELECTION is DIGITAL.
When using the D-SUB to DVI-A cable, the DVI SELECTION is ANALOG.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
NOTE: When using a MAC with digital output: before turning on the MAC, the
DVI Input mode on the monitor must be set to DIGITAL in the DVI SELECTION
menu. To set the DVI SELECTION to “DIGITAL” press the SELECT button then
CONTROL button when the DVI signal cable is connected to the DVI-I connector
of the monitor. Otherwise the MAC may not turn on.
NOTE: Depending on the type of PC/Video card or the type of video signal
cable used, the DVI SELECTION function may not operate.
Controls – continued