Filter
Top Products
English-8
4. Connect all cables to the appropriate connectors (Figure C.1). When using the USB cable, connect the B type connector
to the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on the
computer (Figure C.1a). If using the cord from a USB device, plug into one of the downstream ports of the monitor.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD module
and/or shorten the module’s life.
NOTE: Up to 5 sub monitors can be daisy-chained.
Figure C.1
Highest
Stand
Position
Power cord
30° Tilt
Figure C.1a
A Type
B Type
A Type
B Type
Sensor Port*
1
DVI-D Cable
DisplayPort Cable
USB Upstream Port
USB Downstream Port
5. To keep the cables neatly organized, place them into the cable management system that is built into the stand.
Place the cables in the hooks fi rmly and evenly (Figure C.2 and Figure C.3).
6. Please check that you can still rotate, raise and lower the monitor screen when you have installed the cables.
Figure C.2 Figure C.3
USB Cable
Power Cord
DVI-D Cable
Power Cord
DVI-D Cable
USB Cable
DisplayPort
Cable
DisplayPort Cable
*1 Connect the optional USB optical sensor to this port for self calibration. (See page 25, CD-ROM Version)
MD211G3 paper manual.indb 8MD211G3 paper manual.indb 8 3/27/12 11:18:31 AM3/27/12 11:18:31 AM