Filter
Top Products
English-10
Installation
Attach this product to the display main unit or projector main unit. Depending on the display, an
optional slot board conversion adapter SB-02AM may be required. Refer to the Quick Start Guide of
the SB-02AM on how to install the SB-02AM.
Check with your dealer for the compatible displays and projectors that can be used.
CAUTION:
• During installation, do not leave any foreign objects inside the display or projector.
Do not drop the product, screws and optional slot cover as well.
1. Remove the two screws on the optional slot of slot 2 type to remove the
optional slot cover.
For displays, remove the handle where necessary.
2. Attach this product to a display or projector.
CAUTION:
• When attaching this product to a display, make sure
the top side of this product (side opposite to the side
where the label is pasted) faces the rear of the display.
Damages may result if it is inserted in the opposite
direction.
• When attaching this product to a projector, make
sure the top side of this product faces the top of the
projector. Damages may result if it is inserted in the
opposite direction.
3. Securely fasten this product with the screws on the optional slot.
(tightening torque 49.0N･cm - 68.6N･cm)
Securely fasten the handle with the screws if the handle of the display is
removed. See the manual of the display for the tightening torque of the
handle screws.
CAUTION:
• Do not apply a force higher than the specified force when tightening the
screws. This may result in damages to the screw holes.
Rear of the display
Top side of
this product