Nextar NCD60C Car Stereo System User Manual


 
SEEK 1 / 2:
(only available during radio operation)
In this mode you can select SEEK 1 / SEEK 2 by pressing the + or
button.
SEEK 1: Hold down the > > | or | < < buttons and the radio will tune to the next
station that is detected .
SEEK 2: As long as the > > | or | < < buttons are pressed down, the search function
will continue in the frequency band .
CLOCK FORMAT (2 4 H / 12 H) :
In this mode you can select 24 HOUR or 12 HOUR clock format by pressing the +
or
button.
VOL LAST / VOL ADJ:
In this mode you can select VOL LAST or VOL ADJ mode by pressing the +
TROUBLE SHOOTING
Before using this checklist, please make all the connections first. If you still
have questions after going through the checklist, please consult your local
customer service representative.
Common Symptoms Cause Solution
If the power supply is properly connected to
or – button.
VOL LAST: The radio turns on at the same volume as when it was last
switched off.
VOL ADJ: By pressing the + or
buttons you can pre-select a constant switch-on
volume in the VOL ADJ mode .
5. POWER ON / OFF
Turn the unit on by pressing any button except the RELEASE button on the
faceplate. Press the POWER button to turn the power off .
6. LCD (Liquid Crystal Display)
7. CD SLOT
8. EJECT BUTTON
Press this button to eject the CD.
9 & 10. TUNE, SEEK, TRACK SKIP UP / DOWN BUTTONS
a) During RADIO mode:
Press the > > | or | < < button briefly to tune to a frequency manually.
Press the > > | or | < < button and hold for more than one second to start the
automatic search for a radio station with a strong signal level.
(See also the SEEK 1 / SEEK 2 functions.)
b) During CD mode :
Press the > > | button briefly to play the next track. Press the | < < button briefly to
play the current track from the beginning.
Press the |< < button twice to play the previous track .
Press and hold the > > | or | < < button to skip forward or backward.
11. BAND BUTTON
The car ignition is switched off.
There is no power.
The fuse has blown.
The CDs cannot Presence of CD inside the player.
be loaded.
The CDs are loaded The transport screws have not been
only halfway into removed.
the CD tray.
The disc has been inserted upside
down.
The device does The surface of the CD is extremely
not work correctly. dirty or damaged.
(EJECT, LOAD, Temperature inside the car is too
PLAY) high.
The volume control is set too low.
There is no sound.
The device has not been correctly
connected.
The operation keys 1. The built-in microcomputer is not
do not work. operating properly due to noise.
2. The front panel is not properly
in place.
The installation angle is more than
30 degrees.
The CD player The surface of the road is uneven.
skips.
The surface of the CD is extremely
dirty or damaged.
the car accessory, switch the ignition key to
“ON” or “ACC”.
Replace with another fuse according to the
wiring diagram.
Remove the disc in the player, then put in a
new one.
Remove the transport screws before use.
Insert the compact disc with the label facing
upward.
Clean the CD or try another CD. If this works
correctly, the first CD is probably damaged.
Cool off until the ambient temperature returns
to normal.
Turn up the volume to an audible level.
Check the power and earth connection
according to the wiring diagram.
1. Switch the device off and on again. Or,
press the RESET button to resume the
program.
2. Reinstall the front panel.
Adjust the installation angle to less than 30
degrees.
Wait until the road becomes smoother before
playing the CD.
Clean the CD or try another CD. If this works
correctly, the first CD is probably damaged.
Press the BND button briefly to select the radio broadcasting band you would
like to hear. The AM / FM band is toggled cyclically through the tuning bands
: FM
1 - > FM 2 - > FM 3 - > AM 1 - > AM 2 - >
12. MODE BUTTON
Press the MODE button to change between radio and CD (if a disc is loaded) mode.
Page 3
No radio reception. The antenna cable is not connected. Insert the antenna cable firmly into the
antenna socket of the device.
In automatic search The transmission signals are too Tune in to a radio station manually.
Mode, the radio does weak.
not stop at a trans-
mitting station.
Page 8