Filter
Top Products
23. LOUDNESS BUTTON
Briefly press this button to turn LOUD mode on, which enhances the bass
when the volume level is low. Press again to cancel the loudness effect.
24. CLOCK BUTTON
Press the CLK button briefly to display time on the display.
Press the CLK button and hold until the HOUR flashes on the display, then
press the + or – button to adjust the hour.
Press and hold the CLK button again until the MINUTE flashes on the display,
then press the + or – button to adjust the minutes.
INSTALLATION METHOD
This is an anti-theft installation method.
The main unit wears a METAL MOUNTING SLEEVE.
Please connect the wiring, e.g., the Power Supply, the Speakers and the Antenna,
according to the requirements of this Instruction Manual, then install the metal
mounting sleeve into the car as per the diagram illustrated below.
To properly fix the metal mounting
sleeve, bend the tabs of the sleeve
To raise the anti-skip capability of the unit
WIRING DIAGRAM
METAL SUPPORT STRAP
please ensure the metal support strap is
connected firmly to the car chassis.
DASHBOARD
METAL MOUNTING SLEEVE
To remove the CD player from the cage, insert the
supplied keys into the left and right side slots of the
chassis then pull the chassis out of the cage as shown.
NOTE
Remove the two screws that protect
the CD player during transportation
against the DASHBOARD with a
screwdriver.
UNIT CHASSIS
PLASTIC TRIM FRAME
FACEPLATE
To attach the removable faceplate, insert the right
side of the faceplate into the right side of the CD
player chassis first. Then push the left side of the
faceplate into the chassis until you hear it click.
ANTENNA PLUG
YELLOW
MEMORY B+
BLACK(GND)
RED
POWER B+
FRONT +
4 Ohm
FUSED RCA LINE OUT RED R
FILTER
WHITE L
BOX
0.5A&15A 0.5A
FUSES FUSE BLUE AUTO ANT
WHITE GRAY +
FRONT
4 Ohm
Before installing and operating the before operating the player.
Unit, remove the
metal mounting
sleeve
illustrated by the arrows .
LEFT
SP +
REAR
4 Ohm
Note :
WHITE / BLACK GRAY / BLACK
GREEN VIOLET +
GREEN / BLACK VIOLET / BLACK
RIGHT
SP
REAR
4 Ohm
To draw the front panel out of the chassis,
press the REL button to eject the front
panel from the unit.
1. Make sure that you use speakers with 4 ohm load impedance .
2. Do not allow the auto antenna wire and ground to touch each other.
Page 5 Page 6