Line Level Audio Input
CAUTION! THE AMPLIFIER MUST BE OFF WHENEVER YOU MAKE CHANGES
TO THE INPUT CONNECTIONS.
Cascade Audio Outputs
The “Cascade Audio Outputs” enable you to connect another amplifier to your
preamplifier output. The connectors are gold-plated RCA phono jacks. Connect
them to another amplifier’s inputs with a standard audio patch cable. The outputs
are not buffered; if you wish to daisy-chain more than 5 Niles amplifiers you will
need a Niles AVDA-3 buffered distribution amplifier. A single AVDA-3 will allow
you to daisy-chain 5 amplifiers from each of its three outputs, allowing 30 SI-275
power amplifiers to be fed from the same master preamplifier. If your preamp has
a vacuum tube output stage, you must use a Niles AVDA-3 to drive more than a
single SI-275.
STEP
1. Label all of the interconnecting
cables for the sources they connect to.
2. Connect the sources by inserting the
RCA plugs into the amplifier’s jacks.
DESCRIPTION
Use audio patch cables with RCA phono
plugs attached to the ends.
Connect outputs from your sources to
inputs on the amplifier. Never connect a
source or preamplifier’s input (e.g., record
inputs) to the inputs of your SI-275.
13
INSTALLATION