Filter
Top Products
SECTION THREE - Interfacing
Page 50 961 INSTALLATION MANUAL Revision A
Modifying NMEA output sentences
On the screen, the highlighted sentences will be output, as shown earlier
in Figure 25. Some devices can’t handle all of these sentences correctly, so
you can use this screen to customize the output by turning individual
sentences on or off. In general, you might want to turn on only those sen-
tences used by the particular equipment to which you’re interfacing the
961.
Figure 26 shows the PORT 1 OUTPUT SETUP screen where you can set
the output sentences to the factory default settings.
GSV GPS Satellites In View
HSC Heading Steering Command
MSS MSK Receiver Signal Status
RMA Recommended Min. Sentence A
RMB Recommended Min. Sentence B
RMC Recom. Min. Specific GPS/Transit Data
RNN V1.5 Navigation Route, version 1.5
VTG SOG/COG
WCV Waypoint Closure Velocity (SOA)
WPL Waypoint Location
XTE Cross-track Error
ZDA Estimated Time of Arrival
ZTG Time-To-Go
Table 7: NMEA 0183 sentence identifiers
0183 identifier Meaning