Filter
Top Products
55
Using the Timers—Continued
Notes:
• You must set the clock before you can program the tim-
ers.
• Before programming a timer to turn on the radio, you
must preset the station you want to use. (See pages 46 and
47.)
• If you don’t operate any buttons for 60 seconds while pro-
gramming a timer, the procedure will be cancelled and
the previous display will reappear.
Programming the Timers
1
Press the [TIMER] button repeat-
edly to select Timer 1, 2, 3, or 4,
and then press [ENTER].
If “Clock” appears, you need to set the
clock (see pages 24, 52, and 53).
2
Use the Previous and Next [ ]/
[ ] buttons to select “Play” or
“Rec”, and then press [ENTER].
If you can’t select “Rec”, make sure that
your Onkyo cassette deck or MD
recorder is properly connected to the
MD/TAPE jacks (see pages 21 and 22)
and the Input Display is set accordingly
(see page 27).
/
TIMER
STANDBY/ON
ENTER
Number buttons
or
3
Use the Previous and Next [ ]/
[ ] buttons to select the source,
and then press [ENTER].
You can select the following sources:
CR-525UKD
FM, AM, TAPE, USB, DOCK, CD
or DAB.
CR-425UKD/CR-325UKD
FM, AM, TAPE, DOCK, CD or
DAB.
If you selected “Rec”, only “FM”, “AM”
or “DAB” can be selected as the source.
4
If you selected “AM”, “FM” or
“DAB”, use the Previous and Next
[ ]/[ ] buttons to select the
radio preset, and then press
[ENTER].
5
If you selected “Rec”, make sure
the name of the connected
recorder is flashing on the display,
and then press [ENTER].
6
Use the Previous and Next [ ]/
[ ] buttons to select “Once” or
“Every”, and then press [ENTER].
Select “Once” for on-off operation.
Select “Every” to perform the same oper-
ation every week.