Filter
Top Products
© 2010 directed electronics—all rights reserved 5
FULL FLUSH MOUNTING
Step 1:. Determine where the tweeter will be mounted. Make sure there is a flat area large
enough for the tweeter and no obstructions behind the area.
Step 2: Using the back half of the tweeter housing, mark with a pen the hole needed for the
tweeter.
Step 3: Be sure the hole is large enough for the tweeter housing, but not so large that the
flange will not cover the hole..
Step 4: Cut the hole for the tweeter. When using factory locations, this step can be skipped.
A hole can be cut either with a pair of metal tin snips or a 2" hole saw for hard
materials.
WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.
Step 5: Install tweeter in flush mount housing.
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat
with the front of the surface.
Step 8: Use the supplied pressure ring to secure the housing to the surface.
FLUSH
MOUNT
TRIM RING
TWEETER
PRESSURE
RING
TWEETER
CUP
TWEETER WIRE PANEL
WIRING HARNESS
Figure 3
Figura 3
Abbildung 3
INSTALLING THE CROSSOVER
Step 1: Find a location for the crossover away from any factory or after market electrical wires.
It is recommended to mount the passive crossover close to the amplifier. In the event you
decide to upgrade and bi-amplify the system, mounting the passive crossover close to the
amplifier would simplify the installation upgrade.
Step 2: Remove top cover of crossover housing. Don’t lose it.
Step 3: Mark with a marking pen the two mounting holes.
Step 4: Remove crossover and pre-drill mounting holes using a 1/8” drill bit.
WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.
Step 5: Mount the crossover using the supplied #8 screws.