Filter
Top Products
4 © 2008 directed electronics—all rights reserved
INSTALLING THE TWEETERS
SURFACE MOUNTING
Step 1: Determine the tweeter mounting location, then route the wires from the
crossover to the tweeter location.
Step 2: Place the provided template or tweeter cup against the panel and mark the
two holes at the rear of the housing.
Step 3: Drill the smaller holes using a 1/8" drill bit. These are the mounting screw
holes.
WARNING: Check for clearance of window mechanisms and electrical
wires BEFORE you drill.
Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet
and route the speaker wire from the crossover through the grommet.
Step 5: After removing the surface mount tweeter assembly trim ring, route the
tweeter wires through the larger hole in the housing and connect to the
speaker wires from the crossover.
Step 6: Insert the excess speaker wire into the hole and position the housing so the
housing will not pinch the wires after final mounting.
Step 7: Attach the housing using the supplied screws of the correct length for a solid
mount.
Step 8: Insert the tweeter into the housing and attach the surface mount trim ring.
SURFACE
MOUNT
TRIM RING
MOUNTING SCREWS SURFACE MOUNT HOUSING
TWEETER
TWEETER
WIRE PANEL WIRING HARNESS
Figure 1
Figura 1
Abbildung 1