Filter
Top Products
23
REMOTE operation is possible on this monitor using the GPI/RS-232C terminal.
Each of the items in the GPI screen are compatible with the following terminals.
You can assign functions to each terminal in the menu GPI screen (J page 20).
The functions assigned to each terminal operate when the GND (5 Pin) is connected (ON) or open (OFF).
g Operating conditions
Level operation: operates when GND is connected.
Edge operation: operates when GND changes from
open to connected.
* If you have assigned a level operation function to more
than one terminal, the function operates as long as
one of the terminals is connected.
*1 When both “R-TALLY” and “G-TALLY” are ON at the same time, the tally color becomes orange.
*2 This is only enabled when “RGB-VIDEO” is selected in “YP
BPR/RGB” in the “INPUT SELECT” menu.
GPI terminal
Pin number Signal
1GPI1
2GPI2
GPI Terminal (9P) 3 GPI3
4GPI4
5GND
6GPI5
7GPI6
8GPI7
9GPI8
Assignment items Function Operating conditions
UNDEF
No settings (no terminal assignment functions) —
MARKER1
ON/OFF
Switches the marker display of the marker
decided in “GPI PRESET1” (J page 14) in the
“MARKER” menu.
Level operation
(Connected: ON, Open: OFF)
MARKER2
ON/OFF
Switches the marker display of the marker
decided in “GPI PRESET2” (J page 14) in the
“MARKER” menu.
Level operation
(Connected: ON, Open: OFF)
MARKER
BACKHALF
Reduces the brightness of the background
outside the marker displayed in “GPI PRESET1”
(J page 14) by 50%.
Level operation
(Connected: ON, Open: OFF)
MARKER
BACKBLACK
Reduces the brightness of the background
outside the marker displayed in “GPI PRESET1”
(J page 14) to 0%.
Level operation
(Connected: ON, Open: OFF)
CENTER MARKER
Switches the center marker display ON/OFF.
(When other markers are being displayed, this is
superimposed on the other markers)
Level operation
(Connected: ON, Open: OFF)
INPUT SEL. VIDEO
Switches the input system to VIDEO. Edge operation
INPUT SEL. Y/C
Switches the input system to Y/C. Edge operation
INPUT SEL. SDI1
Switches the input system to SDI1. Edge operation
INPUT SEL. SDI2
Switches the input system to SDI2. Edge operation
INPUT SEL.
YP
BPR/RGB
Switches the input system to YP
BPR/RGB. Edge operation
SD ASPECT
Sets the aspect ratio settings when using SD signal
input. (Disabled when using HD signal and PC signal)
Level operation
(Connected: 16:9, Open: 4:3)
SCAN
You can switch the scan mode between “UNDER”
and “NORMAL”. (Disabled when using PC signal)
Level operation(Connected: UNDER,
Open: NORMAL)
R-TALLY
*1
Lights the red tally.
Level operation
(
Connected
: ON, Open: OFF)
G-TALLY
*1
Lights the green tally.
Level operation
(
Connected
: ON, Open: OFF)
MONO
Switches between color and monochrome
(MONO). (Disabled when using PC signal)
Level operation (
Connected
:
Monochrome, Open: Color)
GAMMA SELECT
Used to select the gamma curve. (Disabled when
using PC signal)
Level operation (Connected: FILM
mode, Open: NORMAL mode)
RGB SYNC
*2
Selects the SYNC when using RGB-VIDEO
input.
Level operation
(Connected: EXT, Open: G-ON)
REMOTE Specifications