Filter
Top Products
CQ-C8803N
Radio
English
19
Radio
This chapter explains how to listen to the radio.
1
Press [SRC] (SOURCE) to select the
radio mode.
2
Press [BAND] to select a band.
Notes:
¡ For tuning in on only stations whose receiving condi-
tions are good in the station search, set LOCAL to ON.
(a page 20)
¡ For reducing noise when a receiving FM stereo wave
is weak, set MONO to ON. (a page 20)
3
Select a station.
Frequency adjustment
[]] (TUNE): Lower
[[] (TUNE): Higher
Note: Hold down for 0.5 sec. or more and release
for station search.
Preset station selection
[{] (P·SET: PRESET): Lower preset number
[}] (P·SET: PRESET): Higher preset number
Note: Direct selection can be executed with [1] to
[6] buttons on remote control.
CQ-C8803N
TA
DISP
PTY
D M
Operation Flow
Up to 6 stations can be preset in AM (LW/MW), FM1,
FM2, and FM3 respectively.
Preset stations can be simply called up by pressing [}]
(P·SET) or [{] (P·SET).
Notes:
¡Direct selection can be executed with [1] to [6] but-
tons on remote control.
¡You can switch between 6 and 18 for FM presetting
stations. (EACH BAND/ALL BAND)
Auto Preset Memory (APM)
Stations with good receiving conditions automatically
preset.
1
Select a band.
2
Hold down
[BAND] (APM)
for 2 sec. or
more.
The preset stations under best receiving conditions
are received for 5 sec. each after presetting the sta-
tions (SCAN). To stop scanning, press [}] or [{].
Notes:
¡New stations overwrite existing saved stations.
¡
Only RDS stations will be saved at default setting (AF ON).
To select non RDS stations too, set AF OFF. (a page 24)
Manual station preset
1
Tune in to a station.
2
Hold down [}] or [{] for 2 sec. or
more.
3
Select a preset number by pressing
[}] or [{].
Note: If [BAND] is pressed while receiving an FM
station, FM broadcasting is changeable among FM 1
to FM 3.
4
Hold down [BAND] (SET) for 2 sec. or
more to determine the selection.
Notes:
¡In step 2, a station can be registered by holding down
the numeric button [1] to [6] for 2 sec. or more.
¡To stop presetting stations, press [D] (DISP: DIS-
PLAY).
¡The operation above allows users to replace the cur-
rent station with the station preset in the selected
number while selecting a preset station.
DISP
PTY
Sound Control
Station Preset
(APM: AUTO PRESET MEMORY P·SET: PRESET)