Filter
Top Products
E
N
G
L
I
S
H
30
CQ-DF701W
39
E
N
G
L
I
S
H
29
CQ-DF701W
38
CD is dirty.
➡Clean CD, referring to the section on “Notes on CD”.
Mounting angle is over 30o.
➡Adjust mounting angle to less than 30o.
Instable mounting.
➡Mount the unit securely with the mounting parts, referring to the
section on installation.
≥ CD is defective.
≥ Mechanical trouble.
➡Press [OPEN] to open the panel and press [<] (EJECT). If normal
operation is not restored yet, call the store where you purchased
the unit or the nearest service station to ask for repairs.
CD sound skips, tone
quality is low.
Sound skips due to vi-
bration.
CD is not ejected.
CD is in the CD compart-
ment but no sound is
made, or CD is ejected
automatically.
CD is upside down.
➡Place CD in the correct direction, and the label side up.
❐ CD
CD is dirty.
➡Clean CD, referring to the section on “Notes on CD”.
Trouble Cause/Step
No sound from left,
right, front or rear
speakers.
Left and right balance, or front and rear balance is off on one side.
➡Adjust BAL/FAD mode as appropriate.
❐ Sound Setting
The right speaker wire is connected to the left speaker and the left
speaker wire to the right speaker.
➡Connect the speaker wires to the correct ones.
Left and right sounds are
reversed in stereo lis-
tening.
Trouble Cause/Step
Cables are not correctly connected.
➡Connect the cables correctly.
❐ Radio
Much noise in FM stereo
and monaural broad-
casts.
Station is too far, or signals are too weak.
➡Select other stations of higher signal level.
The radio antenna is not extended enough.
➡Set the radio antenna enough.
Battery cable is not correctly connected.
➡Connect the battery cable to the terminal that is always live.
Preset station is reset.
Trouble Cause/Step
8 cm disc is ejected automatically.
Troubleshooting (Continued)
Buttons are invalid for
operation.
Battery poles (i) (j) are reversed.
➡Insert the battery correctly.
❐ Remote Control
Wrong the battery.
➡Check the battery.
The battery has run down.
➡Replace the battery.
Remote control is in the wrong direction.
➡Direct the remote control at sensor (REMOTE) on the panel.
Trouble Cause/Step