Filter
Top Products
25
Note:
In picture adjustment mode, bright pictures may not show any noticeable change when contrast is increased.
Likewise, dark pictures will show little change when contrast is reduced.
Picture Adjustments
Item
Contrast
Brightness
Colour
Tint
(NTSC only)
Sharpness
Effect Adjustments
Less More
Darker Brighter
Reddish Greenish
Selects the proper brightness and
density for the room.
Adjusts for easier viewing of dark pictures
such as night scenes and black hair.
Adjusts colour saturation.
Adjust for nice skin colour.
Adjusts picture sharpness.
Notes:
(1)
“Colour” and “Tint”
settings cannot
be adjusted for “RGB” and “PC”
input signal modes.
(2) You can change the level of each
function (Contrast, Brightness,
Colour, Tint, Sharpness) for each
Picture menu.
(3) The setting details for normal,
dynamic and cinema respectively
are memorized separately for each
input mode (AV(S Video), Component,
RGB and PC).
(4) The “Tint” setting can be adjusted
for NTSC signal only during “AV
(S Video)” input signal.
Less More
Less More
Helpful Hint ( /
Normalise
Normalisation)
N
Advanced Settings
Item
Black
extension
W/B High R
W/B High B
W/B Low R
W/B Low B
Gamma
Effect
Less More
Less More
Less More
Less More
Details
Adjusts the dark shades of the image in gradiation.
Adjusts the white balance for light red areas.
Adjusts the white balance for light blue areas.
Adjusts the white balance for dark red areas.
Adjusts the white balance for dark blue areas.
2.0
2.2
2.5
Notes:
(1) Carry out “W/B” adjustment as follows.
A Adjust the white balance of the bright sections using the “W/B High R” and “W/B High B” settings.
B Adjust the white balance of the dark sections using the “W/B Low R” and “W/B Low B” settings.
C Repeat steps A and B to adjust.
Steps A and B affect each other’s settings, so repeat each step in turn to make the adjustment.
(2) The adjustment values are memorized separately for each input mode (AV(S Video), Component, RGB and PC).
(3) The adjustment range values should be used as an adjustment reference.
Less More
Down Up
On the remote control unit, while the “Advanced settings” menu is displayed, if either the N button is pressed at any
time or the
(ACTION button) is pressed during “Normalise”, then all adjustment values are returned to the
factory settings.