Filter
Top Products
19
Rear Panel
12
11
13
14
THRU/OUT JACKS
This 1/4” jack supplies parallel output signals from the associated channel for patching to this amplifier and/or additional
power amplifier inputs. The Thru/Out jack is affected by the position of the associated Channel Mode switch. This 1/4”
jack also provides an unbalanced (tip/sleeve) output to be patched with single-conductor shielded cables.
CONNECTING INPUTS
Input connections are made via the 3-pin XLR (pin 2+) or 6.3 mm plug combination connectors on the rear panel of the amplifier.
The inputs are actively balanced. The input overload point is high enough to accept the maximum output level of virtually any
signal source.
CONNECTING OUTPUTS
All models have one combination 4 pole twist lock output connector per channel. While a 1/4” speaker cable may be connected to
this output, the 4 pole twist lock output connection is the preferred method.
CIRCUIT BREAKER
In the unlikely event of operating conditions that may potentially damage the amplifier, the circuit breaker may trip. After inspecting
the cables and connections, the amplifier can be reset. If the circuit breaker trips a second time, contact the local Peavey authorized
service center.
11
12
13
13
12
11
14