Filter
Top Products
IPR
™
1600/3000/4500/6000
Power Amplifier
Congratulations on your purchase of an IPR power amplifier, designed for years of reliable, flawless operation under rigorous use. The
groundbreaking IPR series utilizes an advanced design that allows Peavey engineers to dramatically reduce weight while increasing
output power, reliability and thermal efficiency. IPR Series amplifiers are designed with a resonant switch-mode power supply and a
high-speed class D topology that yields the highest audio resolution and efficiency available. This revolutionary amplifier offers the
sonic superiority and unsurpassed reliability for which Peavey is famous, in an extremely efficient and lightweight design. Advanced
technology and extensive protection circuitry allow operation with greater efficiency into difficult loads and power conditions. The DDT
™
(Distortion Detection Technique) circuitry ensures trouble-free operation into loads as low as 2 ohms. DDT protects drivers and ensures
that sonic integrity is maintained, even in extreme overload conditions. The IPR’s high-efficiency design allows the amplifier to operate at
very low temperatures, and does not require massive heat sinks to cool. For your safety, read the important precautions section, as
well as input, output and power connection instructions.
Although the IPR amplifier is simple to operate and housed in an ultra-strong, ultra-lightweight chassis, improper use can be
dangerous. This amplifier is very highpowered and can put out high voltages and sizable currents at frequencies up to 30 kHz.
Always use safe operating techniques when operating this amplifier.
Before you send signal through your amplifier, it is very important to ensure that the product has the proper AC line voltage
supplied. You can find the proper voltage for your amp printed next to the IEC line (power) cord on the rear panel of the unit.
Each product feature is numbered. Refer to the front-panel diagram in this manual to locate the particular features next to its
number.
Please read this guide carefully to ensure your personal safety as well as the safety of your amplifier.
ENGLISH
VENTILATION: For proper ventilation, allow 12" clearance from nearest combustible surface.
Make sure that vents are not blocked and air can flow freely through the unit.
Features:
• 2 channel independent, fourth-order Linkwitz-Riley crossovers
• DDT protection
• Revolutionary IPR class D topology
• Detented input controls
• Combination XLR 1/4” inputs
• 4 pole twist lock output connectors
• Ultra-light weight
• Individual signal pass 1/4” jacks on each channel
• LED illuminated
• Standby, LED power present indication
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or and experienced radio/TV technician for help.
16