Filter
Top Products
2-20 C1510M-A (2/03) SECTION 2
3.2 CAMERAS FILE
Close the Comms tab and open the
Cameras file by clicking on its tab.
Identify the ports on the MXB to which
monitor-outs from the SAT are at-
tached. Configure the Cameras file
accordingly.
Figure 2-7
Programming the Cameras File
Figure 2-8
Programming the Link Cameras File
3.3 LINK CAMERAS FILE
Open up the Link Cameras tab next. In
the Link Cameras file, assign unique
logical numbers for the cameras to dis-
tinguish them from non-SAT types. Ac-
cess to link cameras from CM9760-
KBDs attached to the system node use
the logical numbers just referred to, to
call the satellite camera desired. For
each line entry that that defines a link
camera, enter the PTZ port number to
which the SAT for that camera is at-
tached and also enter the port address
(1-16, on the SAT), to which the Link
Camera is attached. An example Link
Camera file is shown to the right.