Philips CEM200 Car Stereo System User Manual


 
21
10 Troubleshooting
Caution
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/support). When you contact Philips,
ensure that your apparatus is nearby and the
model number and serial number are available.
No power or no sound.
Car engine is not on. Turn the car engine
on.
Cable is not correctly connected. Check
connections.
Fuse is burnt. Replace fuse.
Volume is too low. Adjust volume (see
‘Adjust volume’ on page 17).
If the above solutions cannot help, press
the RESET button.
Ensure that the track played is of a
compatible format.
Noise in broadcasts.
Signals are too weak. Select other
stations with stronger signals.
Check the connection of the car antenna.
Change broadcast from Stereo to mono.
Cannot play disc
Ensure that the disc label is inserted with
the printed side facing up.
:LSHWKHGLVFZLWKÀEUHFOHDQLQJFORWK
from the centre to the edge in a straight
line.
This disc may be defective. Play another
disc.
(QVXUHWKDWWKH&'LVDÀQDOLVHG&'&'
R/CD-RW.
Ensure that the CD is not encoded with
copyright protection technologies.
9 Product
information
Note
Product information is subject to change
without prior notice.
Power supply 12 V DC (11 V - 16 V),
negative ground
Fuse 15 A
Suitable speaker
impedance 4 - 8
Maximum power
output 45 W x 4 channels
Continuous power
output
22 W x 4 RMS
(4
10% T.H.D.)
Pre-Amp output
voltage 2.0 V
Aux-in level
500 mV
Dimensions
(W x H x D) 188 x 58 x 206 mm
Weight 1.57 kg
Radio
Frequency range - FM 87.5 - 108.0 MHz
(100 kHz per step
in auto search and
50 kHz per step in
manual search)
Frequency range
- AM(MW)
522 - 1620 KHz
(9 KHz)
530 - 1710 KHz
(10 KHz)
Usable sensitivity
- FM 8 μV
Usable sensitivity
- AM(MW)
(S/N = 20 dB)
30 μV
English
EN