Filter
Top Products
9
CQ-DFX972N
6
E
N
G
L
I
S
H
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM (LW/MW) band selections.
Manual Preset
Memory
Manually save a station in
the preset memory.
Select a band and frequency (step
w and e on the previous page)
q Press and hold [}] or [{] for more than 2 seconds until the preset
number blinks.
w Press [}] or [{] to select a preset number.
e Press and hold [}] or [{] for more than 2 seconds to memorize.
The display blinks once, and a receiving
station is saved in the memory.
Notes:
¡
Frequency setting can be performed even after selecting a preset number.
¡To suspend preset write, press [DISP].
Entering numbers directly from the remote control
Select a band and frequency (step w and e on the previous page)
Press and hold one of the preset button from
[1] to [6] on the remote control
for more than 2 seconds.
Auto Preset
Memory
Automatically save stations
with good reception in the
preset memory.
¡The 6 stations with good reception will be automatically saved in the
memory under preset numbers 1
to 6.
¡Once set, the preset stations are sequentially scanned for 5 seconds each.
¡To stop the scanning, press [}]
or [{].
(Pressing
one of the preset button from
[1] to [6] on the remote control
also can stop the scanning.)
Note: Only RDS stations will be saved at default setting (AF ON). To select non
RDS stations too, set AF OFF. (a Page 11)
Preset Station
Calling
Select a band (step w on the previous page)
Press
[}] or [{] to select the preset number for tuning in the preset station.
Press one of the preset button from
[1] to [6] on the remote control.
Note: New stations are overwritten on existing saved stations after following this procedure.
Entering numbers directly from the remote control
Station Preset
Scanning
Searching
Select a band (step w on the previous page)
Press and hold
[BAND] for more than
2 seconds.