Filter
Top Products
10
3 Press / repeatedly to select hour
format.
4 Press CLOCK SET
» The hour digits blink.
5 Repeat steps 3-4 to set the hour.
6 Repeat steps 3-4 to set the minute.
7 Repeat steps 3-4 to select whether to
synchronize time of this unit with RDS
stations.
[NO SYNC CLOCK]: time
synchronization is deactivated.
[SYNC RDS CLOCK]: the unit
synchronizes time from the RDS
stations automatically.
Note
The accuracy of the transmitted time depends on the
RDS station that transmits the time signal.
If no button is pressed in 90 seconds, the unit exits
clock setting mode automatically.
Turn on
Press .
» The unit switches to the last selected
source.
Note
To select a source, press SOURCE repeatedly or the
source selection buttons on the remote control.
Switch to standby mode
Press again to switch the unit to standby
mode.
»
display panel.
Connect power
Caution
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the unit.
Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
Before connecting the AC adapter, ensure that you have
completed all other connections.
Note
The type plate is located at the back of the main unit.
Connect the power adapter to:
the DC IN socket on the main unit.
the wall socket.
Set clock
1 In standby mode, press and hold CLOCK
SET on the remote control for two
seconds.
» [SET CLOCK]
the display.
2 Press CLOCK SET again.
» The 12/24 hour format blinks.
EN