Philips MCM2050 Car Stereo System User Manual


 
20
No disc detected
Insert a disc.
Check if the disc is inserted upside down.
Wait until the moisture condensation at
the lens has cleared.
Replace or clean the disc.



device has exceeded a certain limit. This
phenomenon is not a malfunction.

supported.
USB device not supported
The USB device is incompatible with the
unit. Try another one.
Poor radio reception
Increase the distance between the unit and
your TV or VCR.
Fully extend the FM antenna.
Timer does not work
Set the clock correctly.
Switch on the timer.
Clock/timer setting erased
Power has been interrupted or the power
cord has been disconnected.
Reset the clock/timer.
8 Troubleshooting
Warning
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before

unsolved, go to the Philips web site (www.

Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
Ensure that the AC power cord of the unit
is connected properly.
Ensure that there is power at the AC
outlet.
As a power-saving feature, the system
switches off automatically 15 minutes after
track play reaches the end and no control
is operated.
No sound or poor sound
Adjust the volume.
Disconnect the headphones.
No response from the unit
Disconnect and reconnect the AC power
plug, then turn on the unit again.
Remote control does not work

select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the unit.
Insert the battery with its polarities

Replace the battery.
Aim the remote control directly at the
sensor on the front of the unit.
EN