Filter
Top Products
FRONT/REAR/ SUB INPUT
Connect signal cables from the head unit to these terminals.
2ch/4ch/5ch INPUT SELECTOR
2ch: Headunit has one pair of cables into front Input.
4ch: Headunit has two pairs of cables into front and rear inputs.
5ch: Headunit has three pairs of cables into front, rear and sub inputs.
HP/LP CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs.
CONFIG
FLAT/OFF: Crossovers are turned o
HP: High pass crossover is on
LP/BP: Low and High Pass crossovers are both on, creating a Bandpass (BP)
setting for midbass drivers.
Notes: The front HP and rear LP crossovers extend to 4kHz, so its possible
to run a component speaker system fully active. The tweeters would be
powered by the front channels and the midbasses by the rear channels. Be
sure to check with your speaker’s manufacture for the correct tweeter and
midbass crossover points to avoid speaker damage.
Subwoofer channel LP crossover and subsonic lter are always on.
LEVEL
Used to reach maximum amplier power with a wide variety of headunits.
FRONT AND REAR SPEAKER OUTPUTS
Used to connect the amplier to speakers. Minimum impedance is 2 ohm stereo/4 ohm
bridged. Use left channel + and right channel - for bridged mode.
SUB CHANNEL SPEAKER OUTPUTS
Used to connect the amplier to subwoofers. Minimum impedance is 1 ohm.
ti1600.5 - Operational Details
© 2011 Phoenix Gold • www.phoenixgold.com