Filter
Top Products
13
Installation
Installing the hide-away unit
Mounting with Brackets
Fig. 10
Mounting with Velcro Tape
Thoroughly wipe off the surface
before affixing the velcro tape.
Fig. 11
DIN Front/Rear-mount
This unit can be properly installed
either from “Front” (conventional DIN
Front-mount) or “Rear” (DIN Rear-
mount installation, utilizing threaded
screw holes at the sides of unit chas-
sis). For details, refer to the following
illustrated installation methods.
Before installing the unit
• Remove the frame and the hold-
er. (Fig. 12)
Pull out to remove the frame and then
loosen the screws (2 × 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
Fig. 12
Holder
Frame
Screw (2 × 3 mm)
Car mat or chassis
Velcro tape
(large)
Screw
(4 × 8 mm)
Car mat or chassis
Bracket
Tapping screw (4 × 12 mm)
Drill 2 to 2.5 mm diameter holes.