Filter
Top Products
! If you do not operate functions except for
Open device, Search device,
DisconnectDevice, Edit device name and
Pin code input within about 30 seconds, the
display automatically returns to the ordinary
display.
! If you do not operate Open device and
Search device within 30 seconds after the
Bluetooth device is paired, the display auto-
matically returns to the ordinary display.
! If you do not operate within 30 secondsafter
Disconnected is displayed, the display auto-
matically returns to the ordinary display.
Using a Bluetooth device to pair
1 Display the connection menu.
Refer to Introduction to connection operations
on the previous page.
2 Turn MULTI-CONTROL to select
Open device.
# If there is previous connection log in this unit,
you can selectthe Bluetooth device from
Paired device.
Refer to Pairing from this unit.
3 Push MULTI-CONTROL up or down to
select the special device.
# Bluetooth devices that are difficultto establish
connection is called special device. If your Blue-
tooth device is listed in the special device, select
the appropriate one.
4 Press MULTI-CONTROL to open the con-
nection.
Ready will be displayed.
This unit is now on standby for connection
from Bluetooth device.
# If five devicesare already paired,
MEMORY FULL is displayed and it is not possible
to perform the pairing operation. In this case, de-
lete a paireddevice first. Refer to Deleting a paired
Bluetooth device on the next page.
# Push MULTI-CONTROL left or right to display
the device name, BD address and PIN code of
this unit.
5 Use your Bluetooth device to establish
connection.
Connection method is different depending on
the Bluetooth device. See the manual of your
Bluetooth device to establish connection.
While connecting, Pairing flashes. If the con-
nection is established, Paired is displayed.
# If the connection fails, ERROR is displayed. In
this case, try again from the beginning.
# PIN code is set to 0000 as the default. You
can change this code in the initial setting. Refer
to Entering PINcode for Bluetooth wireless con-
nection on page32.
Pairing from this unit
1 Display the connection menu.
Refer to Introduction to connection operations
on the previous page.
2 Use MULTI-CONTROL to select
Search device.
3 Push MULTI-CONTROL up or down to
select a device.
4 Press MULTI-CONTROL to start search-
ing.
While searching, Searching flashes. When
available Bluetooth devices are found, device
name or BD address (if names cannot be ob-
tained) is displayed.
# To cancel searching, pressMULTI-CONTROL
again.
# If five devicesare already paired,
MEMORY FULL is displayed and it is not possible
to perform the pairing operation. In this case, de-
lete a paireddevice first. Refer to Deleting a paired
Bluetooth device on the next page.
# If no devicecan be found, NOT FOUND is dis-
played. In this case, check the status of Bluetooth
device and search again.
5 Push MULTI-CONTROL up or down to
select a device name you want to connect.
# If only one device was found, this step cannot
be performed.
Using Bluetooth wireless technology
En
29
English
Section
08