Filter
Top Products
2 Use MULTI-CONTROL to select
Built-in AMP.
3 Press MULTI-CONTROL to turn the inter-
nal power amplifier on.
# To turn the internal power amplifier off, press
MULTI-CONTROL again.
Switching the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
Demonstration in the initial setting menu.
3 Press MULTI-CONTROL to turn the fea-
ture demo on.
# To turn the feature demo off, press
MULTI-CONTROL again.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
! You can also turn on or off feature demoby
pressing DISP/SCRL while this unit is turned
off. For more details, referto About the demo
mode on page 9.
Switching the reverse mode
If you do not perform an operation for about
30 seconds, screen indications start to reverse,
and continue reversing every 10 seconds.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
Reverse mode in the initial setting menu.
3 Press MULTI-CONTROL to turn the re-
verse mode on.
# To turn the reverse mode off, press
MULTI-CONTROL again.
Note
You can also turn on or off reverse modeby press-
ing BAND/ESC/CANCEL while this unit is turned
off. For more details, referto Reverse mode on
page 9.
Switching the ever scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
Ever-scroll in the initial setting menu.
3 Press MULTI-CONTROL to turn the ever
scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.
Activating the BT Audio source
You need to activate the BTAudio source in
order to use a Bluetooth audio player.
This setting is set to on by default. If you do
not use BTAudio, you can turn it off.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
BTAUDIO in the initial setting menu.
3 Press MULTI-CONTROL to turn the
BTAudio source on.
# To turn the BTAudio source off, press
MULTI-CONTROL again.
Initial Settings
En
51
English
Section
11