Filter
Top Products
Route the antenna cable
When routing the lead inside the trunk
When routing the lead through the top of the door
Note:
• Secure the antenna cable with the supplied clamper where required.
Clamps
Use clamps to secure
the lead where
necessary inside the
vehicle.
Make a U-shaped loop in the lead
on the outside to prevent rainwater
from flowing along the lead into the
interior of the vehicle.
Clamps
Use clamps to secure the
lead where necessaryinside
the vehicle.
Waterproof pad
Make sure the waterproof pad
contacts the top of the rubber
packing.
Make a U-shaped loop in the
lead outside the rubber
packing to prevent rainwater
from flowing along the lead
into the interior of thevehicle.
Rubber packing
Installation
Installing the Antenna Unit
Installation using the magnet of antenna
Note:
• If the antenna is mounted on the vehicle’s roof, it can be installed in positions other than those in the
diagram. To ensure the best reception, mount more than six inches away from the edge of the roof.
• If mounted in an exterior location on the vehicle other than the vehicle’s roof, reception may be
poor.
• Do not install inside the vehicle, as reception will be extremely poor.
Secure the antenna cable
clamper
6in. (15.5 cm)
6in. (15.5 cm)
Secure the antenna cable
with the supplied clamper
around here.