Filter
Top Products
11
Information
Provide information about resolution, H/V frequencies,
and polarity of the input signal.
Input Select
This OSD informs the user the current signal that is
displayed.
This OSD will automatically turn off after 2 seconds or
by pressing the “Exit” key.
OSD Warnings
NO SIGNAL
This OSD gives a warning when the selected input
signal is not active. After power on or when the input
signal become inactive, this warning appears.
No signal OSD shall be shown after around 0.5sec from
video mode detection. This OSD shall be turned off
after 5 seconds automatically, or by “EXIT” key. Then
change to power saving mode. If direction key is
pressed during power saving mode, this warning OSD
is opened again.