Filter
Top Products
4
6. Carefully trim headliner from the dome light area
toward the front of vehicle as shown. See figure 4.
Caution: Before cutting headliner material, check
for wiring or other componentry above headliner.
Cut only where indicated.
7. Install the mounting bracket in the O.E.M. dome light
area. Align the front mounting tabs with the openings in
the metal inner roof. Slide bracket rearward until flange
contacts rear edge of recessed area. See Fig. 5.
8. Secure bracket to sheet metal frame using (4) four
# 8 x 3/4" TEK screws. See Figure 6.
FIGURE 4
FIGURE 5
FIGURE 6