PYLE Audio PLCD21 Car Stereo System User Manual


 
9
Troubleshooting
Before go through the checklist, check
wiring connection. If any of the problems
persist after checklist has been made,
consult your nearest service dealer.
No power
Disc cannot be loaded or ejected
-
-
-
-
The car ignition switch is not on.
The fuse is blown.
Replace the fuse.
Presence of CD disc inside the player.
Clean the disc or try to play a new one.
- Temperature inside the car is too high.
Cool off or until the ambient tempera-
ture return to normal.
- Condensation.
Leave the player off for an hour or so,
and then try again.
- Volume is in minimum.
Adjust volume to a desired level.
- Wiring is not properly connected.
Check wiring connection.
If the power supply is connected to the
car accessory circuits, but the engine is
not moving, switch the ignition key to
“ACC”.
Remove the disc in the player, and then
put a new one.
Inserting the disc in reverse direction.
Insert the compact disc with the label
facing upward.
- Compact disc is extremely dirty or
detective disc.
No sound
Sound skips
The operation keys do not work
The radio does not Work.
The radio station automatic selection
does not work.
- The installation angle is more than 30
degree.
Adjust the installation angle less than
30 degree.
- The disc is extremely dirty or defective
disc.
Clean the compact disc, and then try to
play a new one.
- The built-in microcomputer is not
operating properly due to noise.
Press the RESET button.
Front panel is not properly fixed into its
place.
- The antenna cable is not connected.
Insert the antenna cable firmly.
- The signals are too weak.
Select a station manually.