Filter
Top Products
Notes:
- Choose the mounting location where the unit
will not interfere with the normal driving
function of the driver.
- Before finally installing the unit, connect the
wiring temporarily and make sure it is all
connected up properly and the unit and the
system work properly.
- Use only the parts included with the unit to
ensure proper installation. The use of
unauthorized parts can cause malfunctions.
- Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
- Install the unit where it does not get in the
driver's way and cannot injure the passenger if
there is a sudden stop, like an emergency
stop.
- If installation angel exceeds 30°from
horizontal, the unit might not give its optimum
performance
- Avoid installing the unit where it would
be subject to high temperature, such as
from direct sunlight, or from hot air, from
the heater, or where it would be subject to
dust, dirt or excessive vibration.
This unit can be properly installed
either from 'Front' (conventional DIN
Front-mount) or 'Rear' (DIN Rear-mount
installation, utilizing threaded screw
Holes at the sides of the unit chassis).
For details, refer to the following
illustrated installation methods.
Before install the unit, please remove
the two screws.
Din Front/Rear-Mount
Take Out Screw Before Installation
Installation
1
Takeoutscrews
beforeinstallation
1. DIN Front-Mount(Method A)
Installing the unit
1
2
3
53
182
(Fig.1)
1. Dashboard
2. Hoder
After inserting the holder into the
dashboard, select the appropriate tab
according to the thickness of the
dashboard material and ben them
inwards to secure the holder in place.
3. Screw
(Fig.2)
1
6
2
3
7
4
5
1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5X25mm)
5. Screw
6. Strap
Be sure to use the strap to secure the
back of the unit in place. The strap can
be bent by hand to the desired angle.
7. Plain washer
Removing the unit
2
1
3