PYLE Audio PLCDCS330MP Car Stereo System User Manual


 
6
OPERATION
SET THE CLOCK
Press the DSP button (15), the clock is
shown on the LCD display. Then hold
down the button until the clock flashes.
Then press the TUNE/TRACK/SKIP
button (17) to change hours or
TUNE/TRACK/SKIP button (16) to
change minutes.
MUTE
Press MUTE button (2) to mute down
the sound instantly. If any button is
pressed in the mute state, the mute
state is released.
EQUALIZATION
Press EQUALIZER button (12) to turn
on equalization function and to select
desired audio mode. There are five
kinds of mode as below:
SUBWOOFER
Press MODE button (6) for several
seconds to toggle subwoofer output.
Press it for several seconds again to
release this mode.
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (7).
REMOTE SENSOR
Point the remote control handset to
the remote sensor IR (23). Press the
function keys on the handset to control
the system.
ESP FUNCTION
If the unit has the electronic
shockproof function, it can be
shockproof about several tens of
seconds.
AUXILIARY INPUT
The unit can be connected to a
portable audio player through the AUX
IN jack (11).
RESET
RESET button (28) must be activated
with either a ballpoint pen or thin metal
object. The RESET button (28) is to
be activated for the following reasons:
- Initial installation of the unit when all
wiring is completed.
-
All the function buttons do not operate.
- Error symbol on the display.
Note: In this product design, there has
different sound accompanying with every
button pressed and the sound is designed
differently according to the customers.
SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any
button (except CD OPEN/CLOSE/EJ
button (4) and TPAE OPEN/CLOSE
button (24)). When system is on, press
POWER button (9) to turn off the unit.
SOUND ADJUSTMENT
Press PUSH SELECT button (10)
shortly to select the desired adjustment
mode. The adjustment mode will
change in the following order:
By rotating the knob (10) clockwise or
counter-clockwise, it is possible to
adjust the desired sound quality.
Press and hold PUSH SELECT button
(10) for several seconds to enter into
the selection for the situation of beep
sound, then rotate the knob (10)
clockwise or counter-clockwise to
select as follows:
- BEEP 2nd mode:
The beep is only generated when all
allowed double function button is
pressed long (several seconds).
e.g.
When preset button (18) is pressed.
When BND/LOU (ENT) button (13) is
pressed.
When AS/PS button (14) is pressed.
- BEEP ALL mode:
The beep is generated when every
button is pressed.
- BEEP OFF mode:
The beep is disabled.
LOUDNESS
Press the BND/LOU (ENT) button (13)
for several seconds to reinforce the
bass output. Press it for several
seconds again to release this function.
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
BEEP 2ND BEEP ALL BEEP OFF
FLAT CLASSICS POP M ROCK M DSP OFF