Filter
Top Products
7
OPERATION
RADIO OPERATION
• SWITCHING TO RADIO MODE
Press MODE button (6) shortly to
select radio mode, the radio mode
appears in the display together with
the memory band and frequency.
• SELECTING THE FREQUENCY
BAND
At radio mode, press BND/LOU (ENT)
button (13) shortly to select the desired
band.
The reception band will change in the
following order:
• SELECTING STATION
Press TUNE/TRACK/SKIP
button
(17) or TUNE/TRACK/SKIP button
(16) shortly to activate automatic seek
function. Press for several seconds
until “MANUAL” appears on the
display, the manual tuning mode is
selected. If both buttons have not
been pressed for several seconds, they
will return to seek tuning mode and
“AUTO” appears on the display.
• LOCAL/DISTANT
Press LOC button (3) to select
between local and distant stations.
Local setting for reception of strong
station, and a distant setting for
reception of weaker stations. This
function is effect during AUTO SEEK
operation.
• AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic Memory Storing
Press AS/PS button (14) for several
seconds, the radio searches from the
current frequency and checks the
signal strength until one cycle search
is finished. And then 6 strongest
stations are stored into the
corresponding preset number
button.
- Program Scanning
Press AS/PS button (14) shortly to
scan preset station. When the field
strength level is more than the
threshold level of stop level, the radio
is holding at that preset number for
several seconds with release mute,
then searches again.
• STATION STORING
Press any one of the preset buttons
(18) (1 to 6) to select a station which
had been stored in the memory.
Press this button for several seconds
(until 2ND beeps come out), current
station is stored into the number
button.
• MONO/STEREO
Press MO/ST button (8) to select mono
or stereo mode. You can sometimes
improve reception of distant stations
by selecting mono operation.
• SCAN
Press SCAN button (1) to set the
function to scan mode, which scanning
to higher frequency station with
receivable signal and keep on each
station for several seconds.
CASSETTE OPERATION
• SWITCHING TO TAPE MODE
If there is no tape inserted in the
cassette compartment:
Press TAPE/OPEN/CLOSE button
(24), the front panel will slide down
and show the cassette compartment
(26). Then insert the tape into the
compartment. Press the button (24)
again or POWER button (9) to slide
up the front panel.
If a tape is already inserted in the
cassette compartment:
Keep pressing MODE button (6) shortly
until the tape mode display appears.
FM1 FM2 FM3 AM