Filter
Top Products
Unpacking the system
You should have the following:
•one main unit (with 2 main speakers);
• one remote control;
• one AM loop antenna;
• one user’s guide;
• one safety leaflet;
• Owner registration Card.
Back View
1. FM Pigtail Antenna.
2. Subwoofer / Main Speaker Jacks.
3. AM Loop antenna Jacks.
Using the FM and AM Antennas
Before you use your audio system, you’ll want to
make sure both the FM and AM antennas are
positioned properly. Uncoil the FM antenna at
the back of the unit, making sure it is fully
extended (you may even want to tape it to the
wall behind the unit if possible. The higher the
better.) You’ll also need to connect the AM
antenna loop to the back of the unit if you listen
to AM stations. Rotate the AM loop antenna for
better reception.
Connecting the Speakers
Each speaker has a black (negative) / red
(positive) wire and a black (negative) / purple
(positive) wire. When connecting the speakers,
match the red / purple wires to the red / purple
jacks and the black wires to the black jacks.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
3
EN
General Controls
2
EN
Getting Started
4 inches
4 inches
Front View
4 inches
4 inches
2
inches
Side View
Release tab to lock wire in
the terminal.
NOTE: Make sure the insulation
is completely removed from the
ends of the
speaker wires at all connection
points.
Speaker
Wire Connection
Push Speaker terminal tab
down to insert wire.
1
2
3
Main Unit
ON/STANDBY - Turns power on or off (STANDBY
mode).
GAME •mp3• L / R / AUX IN - Jack for auxiliary
connection.
PHONES - Jack for connecting headphones
OPEN•CLOSE - Opens or closes the disc tray.
DISC SKIP - Skips to the next CD in the tray
SOURCE - Selects among CD player, tuner and
AUX.
DIMMER / DEMO - Turns the feature
demonstration on or off in standby mode; adjusts
display brightness.
TIMER - Enters timer setting mode; turns on/ off
timer.
CLOCK - Enters clock setting mode; shows clock
time.
PRESET EQ - Selects among different EQ modes.
DIGITAL TUNING (SKIP FORWARD) - In CD
mode - Goes to the next CD track; selects the next
program location.
In Tuner mode - Tunes up radio frequency; selects
the next preset station.
In Clock or Timer mode - Increases hour and
minute digit.
DIGITAL TUNING (SKIP BACKWARD) - In
CD mode - Goes to the previous CD track; selects
the previous program location.
In Tuner mode - Tunes down radio frequency;
selects the previous preset station.
In Clock or Timer mode - Decreases hour and
minute digit.
PROG•SET - Enters program mode for CD and
Tuner.
In Clock and Timer setting modes - Applies new
settings for Clock and Timer modes.
BAND/AUTO PROG - In Tuner mode - Changes
among tuner bands. Enters auto preset program
in FM mode.
PLAY / PAUSE - In CD mode - Plays and
pauses CD.
TUNE•PRESET - In CD mode - Stops CD
playback.
In simple mp3/WMA mode - Returns to the first
track on the current disc.
In Tuner mode - Sets tune or preset mode.
BASS BOOST - Turns BASS BOOST on or off.
REPEAT - Selects among repeat modes.
VOLUME CONTROL - Adjusts volume.
Tips:
In STANDBY mode, press ON/STANDBY to
turn the system on in the previously used
mode. Press CD, TUNER, or AUX (Remote
only) to select the corresponding mode. Look
at the display icons to identify the current
mode.
RS2654_EN(Canada) 2/7/06 3:28 PM Page 8