Filter
Top Products
SURFACE MOUNTING THE ND4 /ND8 TWEET-
ERS
The following instructions explain how to surface
mount the ND4/ND8 Tweeters.
1. Place the mounting plate on the surface that the
tweeter will be mounted to. Mark two (2) oppos-
ing mounting holes and the center wire access
hole.
2. Drill a 1/4 inch (6.4mm) hole for the wire access.
Drill two (2) 1/8 inch (3mm) holes for the mount-
ing screws.
3. Route the hook up wire through the center hole.
4. Place the mounting plate in position by threading
the hook-up wires through the center hole. Mount
the mounting plate down using the provided
screws.
5. Attach the hook-up wire to the tweeter. Note: Be
sure to observe proper speaker polarity.
6. Snap the tweeter onto the mounting plate.
5
Mounting Holes
Mounting Holes
Hook-up Wire
Tweeter
Center Wire
Access Hole
Mounting
Plate