Filter
Top Products
The following instructions explain how to surface mount the ND4
Tweeters.
1. Place the mounting plate on a surface that the tweeter will be
mounted onto. Mark two (2) opposing mounting holes and the
center wire access hole.
2. Drill a 1/4 inch (6.4mm) hole for the wire access. Drill two (2) 1/8
inch (3mm) holes for the mounting screws.
3. Route the hook up wire through the center hole.
4. Place the mounting plate in position by threading the hook-up wires
through the center hole. Mount the mounting plate down using the
provided screws.
5. Attach the hook-up wire to the tweeter.
Note: Be sure to observe proper speaker polarity.
6. Snap the tweeter onto the mounting plate.
9
SURFACE MOUNTING THE ND4 TWEETER
Center Wire
Access Hole
Hook-Up
Wire
Mounting
Holes
Mounting
Holes
ND4
Tweeter