Filter
Top Products
– 63 –
– 62 –
SYMPTOM DIAGNOSIS REMEDY
ERROR 6
(Transverse Error)
Transverse motor or
switch is defective.
Traverse area
damaged
Check CD mechanism motor,
switch and transverse area.
SYMPTOM DIAGNOSIS REMEDY
Disc will not load
into Source Unit
(also see error codes)
Voltage applied to Red
and Yellow wires is not
between 10.8 and 16
volts or there is no
voltage present
Check battery, fuses and
connections and repair or replace
as necessary. If voltage is above
+16 volts, have the electrical
system inspected by an autho-
rized car service center
Disc will not eject
(also see error codes)
Voltage applied to
Yellow wire is not
between 10.8 and 16
volts or there is no
voltage present
Check battery, fuses and
connections and repair or replace
as necessary. If voltage is above
+16 volts, have the electrical
system inspected by an autho-
rized car service center
ERROR 1
(Initialize Error)
No initialization
Press the reset button
Mechanism is jammed
and loading motor (or
driving circuit) is
defective
Repair the mechanism and
loading motor (or driving circuit)
ERROR 3
(Loading Error)
Foreign objects are
preventing the disc
from loading
Check CDP mechanism load area
by removing faceplate and repair
as necessary
Loading area in
mechanism and load-
ing motor (or driving
circuit) is defective
Repair the mechanism and load-
ing motor (or driving circuit)
ERROR 4
(Eject Error)
Foreign objects are
preventing the disc
from ejecting
Check CDP mechanism eject area
by removing faceplate and repair
as necessary
Ejecting area in mech-
anism and ejecting
motor (or driving cir-
cuit) is defective
Repair the mechanism and load-
ing motor (or driving circuit)
ERROR 9
(TOC Error)
Disc is warped
cracked or severely
damaged
Put in a different disc!
The laser pickup is
defective
Have a service center
repair the laser pickup
Servo unit in CDP
mechanism is not
operating properly
Check the servo circuit area and
repair as necessary
CD skips
excessively
Source unit mounted
at an incorrect angle
Check mounting angle of source
unit (mount within ±20˚ from hor-
izontal) and repair as necessary
Source unit not
secured properly
(Standard Mount)
Check tightness of installation
sleeve and backstrap and repair or
replace as necessary
Source unit not
secured properly
(ISO Mount)
Check tightness of mounting
screws and repair or replace as
necessary
Radiated Noises No RF suppression
of blower motors
Connect filter cap (Radio Shack
#272-1085) in-line on B+ as close
to blower motor as possible
No RF suppression
of switches
Connect a .1µf – .01µf non-polarized
capacitor across switch contacts
ERROR 7
(Servo Error)
Excessive dirt or dust
on disc
Clean disc to remove dirt or dust
as necessary
Disc is warped
cracked or severely
damaged
Put in a different disc!
Excessive scratches
on disk
Put in a different disc!