Filter
Top Products
11
Names of Things and What They Do
After connecting two SA-1000s together with one or two
audio cables (1/4-inch phone type), you can easily play
back high power sounds (350 W + 350 W) in stereo.
4. STEREO LINK IN Jack
When using the Stereo Link function, input audio from
the left channel SA-1000 here.
You can also use this as an external input jack for mono
input.
0 dBu input level is supported.
5. STEREO LINK OUT Jack
This outputs audio to the right channel SA-1000 when
the Stereo Link function is used.
When the STEREO LINK OUT jack is in use, the left
channel audio is output in mono from the SA-1000's
speakers.
Output level is 0 dBu.
* Signals output from these jacks are not routed through the
MASTER section (EQUALIZER, ORGAN ENHANCE,
AMBIENCE, VOLUME).
For further instructions on connecting with Stereo Link,
refer to “About Stereo Link” (p. 14).
6. LINE OUT Connectors
These are XLR type connectors for balanced output (left
and right stereo output).
Connect a mixer, recording device, or other equipment
here. Rated output level is +4 dBu.
fig.01-06
7. GND LIFT Switch
Using external equipment connected to the LINE OUT
connectors may result in generation of the “hum” of loop
ground noise. If this occurs, you may be able to mitigate
the problem by sliding this switch. Normally, this is set
to “OFF.”
ON:
Pin 1 is disconnected from the SA-1000’s ground.
OFF:
Pin 1 is connected to the SA-1000’s ground.
8. DEDICATED SPEAKER Jack
Use this jack to output sounds to the SA-1000W
subwoofer.
Use the special connection cable included with the unit
to connect to the SA-1000W’s INPUT jack. This provides
powerful low end to the sound.
* Turn off the power on the SA-1000 before connecting or
disconnecting cable.
• Connect only the SA-1000W. Never connect any other
equipment.
• Be sure to use only the connection cable included with
the unit to connect the subwoofer. Do not use ordinary
audio cables.
STEREO LINK LINE OUT
SPEAKER
SA-1000_r_e.book 11ページ ２００７年１０月１日 月曜日 午後１時５２分