10
This LCD monitor allows you to set up the following:
SETTING PROCEDURE
1.Press and hold the GREEN button on the remote control for 5
seconds. (Installation Mode will appear)
2.
Use the 5 or 6 button to highlight each option, use the
1 or
2
button to adjust each option.
Press the MENU button to exit
the mode.
■ On Program
Select ON program using the
5 or 6 button, select the start up
position using the
1 or 2 buttons.
(Off/ AV1/ RGB/ AV2/ AV3/ PC/ DVI or Network)
■ Max Volume
Select Max volume using the
5 or 6 button, use the
1 or
2 buttons to set the maximum volume required.
■ Winter mode
This Function can be activated when the LCD monitor is used during
cold temperature conditions, approximately 38˚F/ 4˚C or below to
maintain picture performance.
Using the
5 or 6
button select winter mode, once highlighted
you can select ON or OFF by pressing the 1 or 2 button.
IMPORTANT: The AC cord should not be disconnected during the
operation of Winter mode function.
When in winter mode, power consumption is higher than normal
standby consumption. This is entirely due to the operation of heating
circuitry. We strongly recommend to turn off Winter mode when the
ambient temperature is above 38˚F/ 4˚C.
■ RC inhibition
You can prevent unwanted remote control operation by selecting RC
Inhibition.
Select using the
5 or 6
button. Press the 1 or 2 button
to select On or Off.
To re-instate RC operation press and hold the green button on the
remote control and select RC inhibition OFF.
■ Child Lock
You can prevent unwanted operation of the LCD monitor via the
buttons on the rear of the monitor.
Select using the
5 or 6
button. Press the 1 button to select
On or OFF. The ‘Child Lock’ OSD will appear if buttons are pressed
when child lock is On.
✐ Standby operates normally when childlock is set “On”.
■ Address
Set the address for the LCD monitor (0 - 999).
■ Baud rate
Select Baud rate using the
5 or 6
button. To set transmission
speed RS232 or LD-NET communication for 19200 or 9600 Baud
rate by pressing the 1 or 2 button.
■ Panel Protect
Select Panel Protect using the
5 or 6
button, once highlighted
you can select ON or OFF by pressing the 1 or 2 button.
■ AV Auto shut off
Select AV Auto Shut Off using the
5 or 6
button, once high-
lighted you can select On or Off by pressing the 1 or 2
button.
■ LED Light setting
Select LED Light setting using the
5 or 6
button, once high-
lighted you can select On or Off by pressing the 1 or 2
button.
■ DCR
Select DCR using the
5 or 6
button, once highlighted you can
select On or Off by pressing the 1 or 2 button.
■ Network Initial
This function automatically installs the IP Address, Subnet, Gateway
and DNS information.
■ Temperature Error
This function can record times for abnormal temperture.
■ IP Address / Subnet / Gateway / DNS
These 4 items display the LD-Net information. If LD-NET is NOT
connected, all the items would be displayed as “000000000000”.
✐ Disconnecting the mains supply before exiting Installation Mode
will cancel the following features On program, RC inhibition, Address
and Baud Rate.
INST
INST
ALLA
ALLA
TION MODE
TION MODE
GB
GB
Installation Mode
Temperature Error
VER -.--
Network Initial
>>>
Installation Mode
Downloaded From TV-Manual.com Manuals