Filter
Top Products
13
Installation
KH 2377
GB
IE
To avoid function disturbances the installation angle should be less than 30°. ■
Do not install the device in a location where it will be subjected to high ■
temperatures (i. e. direct sunlight or heating vents), heavy contamination and
strong vibrations.
In the e
vent that changes to the vehicle are necessary contact your vehicle ■
dealer/qualifi ed radio installation facility.
Installing the device into the ISO duct
Pull the installation bracket
68
and the bezel frame
67
from the device's
housing.
Place the installation bracket into the ISO mounting duct.
Bend the tabs on the installation bracket with a scr
ew
driver so that the
bracket is fi xed fi rmly into the mounting duct (see diagram).
Check to make sure that the bracket is securely fi xed.
Connect the ISO socket block of the device with the two ISO plugs on your
vehicle.
Connect the antenna cable from the vehicle antenna to the antenna sock
et
on the device.
Feed the microphone unit cable into the mounting duct and connect it to the
micr
ophone unit socket. Place the cable in such a way that the microphone
unit can be secured in the vehicle interior later
, see also the chapter "Using
the microphone" on page 30.
Contingently connect the audio cinch cable of an external amplifi er to the
LINE OUT socket
39
on the device.
Contingently connect the audio cinch cable of an external subwoofer to the
yellow cinch socket SUBWOOFER
37
on the device.