Filter
Top Products
4
3. INSTALLATION AND WIRING CONNECTIONS
Before Installation
1. Before starting, be sure to disconnect the battery’s negative “
–
” terminal to
prevent accidents due to short-circuits.
2. Location – Consider safety and operability when selecting a place for installation.
Avoid the following.
• Locations where the unit will hamper or interfere with driving.
• Locations where the unit could injure passengers if the car stops suddenly.
• Locations exposed to direct sunlight or hot air from the heater, etc.
• Locations where the unit may be exposed to rain or water.
3. Be sure to use the included screws and brackets. Screws other than those
supplied could damage the unit.
4. When drilling holes to mount the receiver, be sure to check beforehand that
there are no obstructions or items on the other side that could be damaged (fuel
tank, wire harnesses or other electronic devices).
Accessories
Mounting bracket .............. 2 pieces
Mounting screw ................. 4 pieces
Canoe clip ......................... 4 pieces
CeNET cable ..................... 1 piece