Filter
Top Products
5
Installation Example (Installing the unit under the driver’s seat)
1. Attach the mounting brackets to the sides
of the SIR-CL1 using the screws provided.
2. Select the location on the floor mat. Drill
holes in the floor mat to match the positions
of the holes in the mounting brackets.
3. Insert the canoe clips from the rear of the
floor mat and install the SIR-CL1.
There are three mounting holes on each
side of the SIR-CL1. Select the
appropriate holes to match to the
installation location.
Connection Example and Identification of Parts
CeNET input/output terminal
Connect to the main unit or CD/MD changer
using the CeNET cable as specified.
RCA pin terminals
These are used to output audio when the
DSC920S (sold separately) is used to operate
the receiver.
ANTENNA terminal
Connect to the SIRIUS antenna (sold
separately)
COMMANDER
Controller terminal
Connection for DSC920S (sold separately)
COMMANDER Power Supply terminal
Used only when operating the SIR-CL1 with the
DSC920S (sold separately)
CeNET/STANDALONE switch
This switch is used to select the operating type:
CeNET (headunit) or STAND ALONE
(DSC920S)