Filter
Top Products
22
Error displays/Messages
Automatic tuning is not possible.
• Setting of the local seek mode is not correct.
tTuning stops too frequently:
Set “LOCAL-ON” (page 14).
tTuning does not stop at a station:
Set “MONO-ON” (page 14).
• The broadcast signal is too weak.
tPerform manual tuning.
During FM reception, the “ST” indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
tSet “MONO-ON” (page 14).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
tSet “MONO-OFF” (page 14).
RDS
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
tDeactivate TA (page 10).
No traffic announcements.
• Activate TA (page 10).
• The station does not broadcast any traffic
announcements despite being TP.
tTune in another station.
PTY displays “- - - - - - - -.”
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the program type.
CHECKING
The unit is confirming the connection of an iPod.
tWait until confirming the connection is finished.
COM ERR (iPod Communication Error)
Due to incorrect connection, data did not transfer
successfully between the unit and iPod.
tReconnect the iPod and select iPod.
ERROR
• The disc is dirty or inserted upside down.
tClean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play due to a problem.
tInsert another disc.
• iPod was not automatically recognized.
tReconnect it again.
•Press Z to remove the disc.
FAILURE
The connection of speakers/amplifiers is incorrect.
tSee the installation/connections manual of this
model to check the connection.
L. SEEK +/–
The local seek mode is on during automatic tuning.
NO AF
There is no alternative frequency for the current
station.
tPress (SEEK) –/+ while the program service name
is flashing. The unit starts searching for another
frequency with the same PI (Program
Identification) data (“PI SEEK” appears).
NO INFO
Text information is not written in the MP3/WMA/
AAC file.
NO IPOD
The iPod is not connected.
tConnect iPod to dock connector.
If “NO IPOD” appears after connecting the iPod to the
dock connector, disconnect the iPod from the dock
connector, then reconnect.
NO MUSIC
The disc/iPod does not contain a music file.
tInsert a music CD in this unit.
tConnect an iPod with a music file in it.
NO NAME
A disc/album/track name is not written in the track.
NO SUPRT (iPod Not Support)
• Third-generation iPod is connected.
• iPod connection was interrupted for over 30 seconds
during data transfer.
NO TP
The unit will continue searching for available TP
stations.
OFFSET
There may be an internal malfunction.
tCheck the connection. If the error indication
remains on in the display, consult your nearest
Sony dealer.