Filter
Top Products
28
HDMI Control
Other Issues
Symptom Cause/Action
Connected equipment
cannot be controlled using
the buttons on the head
mounted unit
p Make sure the connected equipment supports the HDMI CEC
functions.
p Make sure “Control for HDMI” setting of the connected
equipment is configured correctly. For details, refer to the
instruction manual of the equipment used.
p The connected AV amplifier (receiver) may not be compatible
with the system’s “Control for HDMI” function. “Control for
HDMI” function will not work correctly in this case.
p Controlling connected equipment by pressing buttons on the
head mounted unit may not be possible immediately after turning
the system on, or immediately after activating “Control for
HDMI” in “General Setup.”
p Make sure the “Control for HDMI” setting in “General Setup” is
set to “On” (page 22).
Symptom Cause/Action
The power indicator keeps
flashing in red
p If the indicator flashes twice every 3 seconds, the head mounted
unit or processor unit may be damaged. Contact your Sony dealer
or local authorized Sony service center.
p If the indicator flashes three times every 3 seconds, the processor
unit has overheated. Wait until the unit cools off and flashing
stops. Make sure not to cover or obstruct the ventilation openings
of the processor unit for proper ventilation.
p If the indicator flashes four times every 3 seconds for a minute,
the head mounted unit has overheated. Wait until the unit cools
off and flashing stops.
p If the indicator flashes five times every 3 seconds for a minute,
both the head mounted unit and processor unit have overheated.
Wait until the units cool off and flashing stops.
When the system is off,
video and audio from the
playback equipment is not
played on a TV connected
to the HDMI OUT jack
p Confirm that the HDMI cables are fully connected.
p Set “HDMI pass-through” in “General Setup” to “On” (page 22).
p Switch the input source on the TV to this system.
p Check the HDMI output settings on the playback equipment.
“Control for HDMI” on a TV
cannot be used to control
the playback equipment
even when the system’s
HDMI pass-through is used
p Refer to the instruction manual supplied with your TV, and in the
TV’s “Control for HDMI” setting, specify this system as the
controlling device.
Head mounted unit buttons
are unresponsive
p Buttons on the head mounted unit do not function unless you are
wearing it.