Filter
Top Products
52
1 DATA(FL) O Serial data signal output to the display driver.
2 CLK(FL) O Serial clock signal output to the display driver. L: Active
3 A1-IN I A1 Control input. (Fixed at L)
4 SIRCS I Remote control input.
5 to 7 NC — Not used.
8 MUTE O Line out muting output. L: Mute
9 AD/DA RESET O Reset signal output to the AK4524. L: Active
10 AD/DA LATCH O Latch signal output to the AK4524. L: Active
11 LD-LOW O Loading motor voltage control output L: High voltage H: Low voltage
12 LDIN I Loading motor control input. H: IN
13 LDOUT O Loading motor control output. H: OUT
14 MOD O Laser modulation switching signal output. L: OFF H: ON
15 BYTE I Data bus changed input. (Connected to ground.)
16 CNVSS — Ground.
17 XIN-T O Not used .
18 XOUT-T O Not used .
19 RESET I System rest input. L : ON
20 XOUT O Main clock output. (10MHz)
21 VSS — Ground.
22 XIN I Main clock input. (10MHz)
23 VCC — Power supply. (+3.3V)
24 NMI I Fixed at H. (Pull-up)
25 DQSY I Digital in sync input. (Record system)
26 P.DOWN I Power down detection input. L: Power down
27 SQSY I ADIP (MO) sync or subcode Q (PIT) sync input from CXD2662R.(Playback system)
28 K.B-CLK I Keyboard clock input.
29 LDON O Laser ON/OFF control output. H: Laser ON
30 LIMIT-IN I Detection input from the limit switch. L: Sled limit-In H: Sled limit-Out
31 A1 OUT O A1 Control output.
32 XINIT I Interrupt status input from CXD2662R.
33 BEEP O Beep output.
34 LRCKI I LR clock input.
35 WR PWR O Write power ON/OFF output. L: OFF H: ON
36 IIC CLK I/O IIC serial clock input/output.
37 IIC DATA I/O IIC serial data input/output.
38 SWDT O Writing data signal output to the serial bus.
39 VCC — Power supply. (+3.3V)
40 SRDT I Reading data signal input from the serial bus.
41 VSS — Ground.
42 SCLK O Clock signal output to the serial bus.
43 REC-SW I Detection signal input from the recording position detection switch. L: REC
44 CLIP DATA O CLIP serial data output.
45 RX0(CLIP) I CLIP serial data input.
46 CLIP CLK O CLIP serial clock output.
47 DIG-RST O Digital rest signal output to the CXD2662R and motor driver. L: Reset
48 SENS I Internal status (SENSE) input from the CXD2662R.
49 PLAY-SW I Detection signal input from the playback position detection switch. L: PLAY
50 XLATCH O Latch signal output to the serial bus.
51 OUT-SW I Detection signal input from the loading out detection switch.
52 RDY I Fixed at H. (Pull-up)
53 ALE/RAS O Microprocessor mode output. (Not used.)
54 HOLD I Fixed at H. (Pull-up)
FunctionPin NamePin No. I/O
• IC1 M30805SGP SYSTEM CONTROL (MAIN BOARD)